It seemed like a good idea at the time to buy 2 because you'll get screwed on shipping. Typical location of a neutral safety switch on a transaxle. Any abraded or pinched wires? Are all wires clean and with solid connections? Enjoy the road rashing with that bike. Be sure to position the battery cable end away from the battery terminal so there is no chance of arching. Aug 06, 2009 Check the fuses. A guide to determining which transmission model you have based on the year, make, model and engine size. Use this guide to find out.
. Check the back-up lights to see that they are on. There are two screws holding the safety switch to the floor board. I was wondering if anyone else has replaced the neutral safety switch? When the reverse light switch is not part of the neutral safety switch, it seldom needs adjustment, as it is directly activated by the transmission or the gear selector linkage. Hold on, as WheelZine answers such questions, by describing the function of a neutral safety switch, along with the symptoms, testing, and replacement of one that has gone bad.
We all know what that is I hope!! This ensures that a manual transmission vehicle can't be started unless the clutch pedal is depressed. I would try to adjust the old switch before replacing it. Aug 15, 2012 Your safety interlock switch is going out or is not adjusted properly. Some content will be hidden from you. If no neutral light, check the neutral switch and neutral switch wire on center casing. Others must be replaced as a unit.
Lie back under the dash and test the continuity of the wires going to and coming from the safety switch. As I recall you will need to mess with the wiring I think mine only needed two wires and it least in my case snip off the metal clip. The switch is on the transmission in the engine compartment. Electrical connectors are plastic and can become brittle over time, so be careful not to break the connector when unplugging it from the switch. The neutral safety switch is located under the clutch on all vehicles that have manual transmissions. Good luck and have a nice day. For more information about your issue and free valuable downloads that you will need please visit the websites below.
I had the same problem. Others have separate units for these two distinct functions. The bike will punish you for the lazy kick. You better change that leaking neutral switch. In this case, the safety switch must be replaced as soon as possible to avoid serious accidents or injuries.
Are all wires clean and with solid connections? Here we provide step-by-step instructions for remove and replacing a transmission. If you want to adjust the switch, loosen the botls holding the switch and follow steps 7-8 below. Did a wire come unplugged? This would allow you to kick it while in gear as long as you hold the button in. Good luck and have a nice day. If floor jack is used, the raised vehicle must be secured with jack stands. Starting the bike proved to be much harder than I thought, we must have pushed the bike up and down my street 50 times and only managed to get it started once. Try a jump start from your car battery.
This switch is connected to a part called the starter solenoid, which activates the starter motor, which in turn starts the engine on turning the key. Perhaps Yamaha retard the ignition so that it fires after top dead centre when the bike is in neutral. The neutral start and backup switch are one unit mounted on the top left end of the transaxle. Excessive heat can ruin a perfectly good transmission very quickly. Remove the neutral safety switch.
The purpose of the neutral safety switch is to prevent the engine from cranking and possibly starting when the transmission is in gear. Make sure that there is a Oil catcher around even if you have already drained the oil. The are designed to prevent the car from being started while still in gear. Here's one link but there are other sites that carry them. If you're already planning on replacing it, might be worth to just try and snug it up. If no voltage is present, replace the switch.